| Product Description 1Set 3D Printer z-probe BLTouch Auto Leveling Sensor Newest Auto Bed Leveling Sensor Touch for Improve Printing Precision
1Set 3D Printer z-probe Touch Auto Leveling Sensor Newest Auto Bed Leveling Sensor Touch for 3D Printer Improve Printing Precision
Voltage
5V
Current
15mA
Maximum(Peak)Current
300mA
Color
Semitransparent Black
Cable Length
150mm
Weight
0.35 oz(10g)
Wiring
3Pin:Black(-,GND)
Red(+5V)
Blue(control Signal)
2Pin:Black(-,GND)
Yellow(Zmin)
3D printer z-probe Touch uses the same servo signal which used in previous servo line.
Solenoid Push-pin Up servo signal 90Degree(ex : M280 P0 S90 )
Solenoid Push-pin Down servo signal 10Degree(ex : M280 P0 S10 )
Manual Self-test servo signal 120Degree(ex : M280 P0 S120)
Alarm Release servo signal 160Degree(ex : M280 P0 S160)
3D printer z-probe Touch can be operated in the following condition.
- One I/O (PWM or Software PWM) for control
- One I/O for Zmin
- GND and +5V power
However, Firmware updating might be needed on a case.
If you use this on an Anet A8 then you need to cross over the YELLOW & BLUE wires. Couldn't figure out why it wouldn't work until I read the head unit. The Yellow is the endstop and the Blue is the pwm input, I just cut them and reversed them.
package listing:
window.adminAccountId=234405212;
. Brand Name:FYSETCItem Type:Leveling ModulesModel Number:3d printer z-probe touch |
