| Product Description Heating tube 6*20mm 12V 24V 50W Ceramic Cartridge Heater 1M 2M Reprap&Mendel For V6 J-head Extruder 3D printer part
1. The effective heating part of the heater must keep dry.
2. The electrical connector of the single-ended heater should be placed out of the insulation
layer and heating room, and the working voltage shall not exceed its rated value of 10%. The
shell should be effectively grounded.
3. Electric components working environment, the temperature should not be greater than 95
degrees, no explosive or corrosive gases.
4. Electric components should be stored in a dry place.
Product specification
Voltage: 12V/24V
Power: 50W
Heating head size: 6 * 20mm
Heating head material: 304 stainless steel
Line length: 1M and 2M for option
Line thick: 0.5 mm2; (The cross section of the copper wire inside the heater is 0.5mm2;)
Color: as shown in the picture
Heating temperature: up to 350 degrees
The improvement compared to ordinary red heater
1. From the original ordinary 0.3-line high-temperature line to 0.5-line thick white high-
temperature line, can bear higher temperature, and looks more beautiful.
2. From the original 40W power to 50W, therefore, the maximum temperature increases from
300-31 to 340-350 or so.
3. The new version heater used in all imported skills, the use of 304 stainless steel, with the
internal use of 2080 nickel chrome wire to achieve maximum service life.
4. Support the customization of different specifications, length, resistance of the heater.
5. Can be used with the new HT-NTC100K temperature thermistor (Temperature measurement
can be up to 350 degrees).
window.adminAccountId=222168877;
. Brand Name:ZANYAPTRItem Type:Cartridge Heater |
