| Product Description trianglelab Adapter Board Filament Sensor Kit or BL Touch Adapter Board pin 27 board for Creativity for 27 CR-10 Ender-3
If you need to sendUPS/Fedex/TNT/DHL,please contact us.We need to discuss the freight with you.
The trianglelab has always been concerned about product quality.We are developing products and working hard to improve the quality.We will not abandon our reputation because of many cheap products on the market.It is believed that only high quality products can ensure the quality of your work and bring safety to your work.
Some of our products may be more expensive than others,but please believe in our quality and believe that you will not regret when you receive the goods.
Benefits:
As always, maintain our excellent quality.Each adapter plate is packaged in an electrostatic bag.
Device Compatibility:
1 Filament Sensor Kit
2 Bl touch Sensor or 3D touch Sensor
*Cannot support two sensors at the same time
Printer Compatibility:
Ender-3
Ender-3 pro
Ender-5
CR-10
CR-10 mini
Incompatible With:
CR-8
Anet A8
Ender-2
Ender-4
Attention:
The pin 27 board makes installing a bltouch or filament sensor fast and easy. Normally you would need to cut the ribbon cable and solder into the pin 27 but with the board its plug and play.(after firmware update)
Make sure to check your wire configuration on your bltouch or filament sensor. The new bltouch sensors should plug right into the board without depining the connector.
Left to right: Brown-Ground, Red-5v, Yellow/Orange-Signal
Disconnect lcd ribbon ext1 on the control board
Connect Ext1 to the pin 27 board
Connect bltouch to the 3 pins on the pin 27 board. Left to right: Brown-Ground, Red-5v, Yellow-Signal
Connect the pin27 to the main board. Make sure to align the header pins from the pin 27 to the main board.
Photo display:
Ender-
window.adminAccountId=220428509;
. Brand Name:DFORCEItem Type:ModuleModel Number:Adapter Board pin 27 board |
